Replacement Ignition Fits BBQ Models By Charbroil and Kenmore.

This ignition electrode is a strange design compared to most barbecue grill ignition electrodes. The tip of the ignitor is inside the stainless box with brackets that seem to be closing off the igniter when it is installed. One side has a tab that sticks up and the other side has a tab that bends in towards the tip of the electrode. The role of the collector box bracket is to protect the electrode but also provide a clean surface for the ignition to spark against while collecting the flow of gas emitting from port holes in the burner. Allowing a adjustable piece to affect thje gap will always be a good design because it allows us to change the gap and make a better spark.

803080

Kenmore replacement gas bbq grill ignitor electrode with collector box bracket and wire. Replace the electrode to repair the barbecue grill ignition. Collector box is tooled for installation with a lip on two sides. One end is bent-in towards the electrode to allow the gap to be adjusted for better sparking. The electrode wire is approximately 12 inches long with a female spade connector designed to plug into the barbecue module.

$12.


Free Shipping USA!!
kenmore gas barbeque grill repair electrode replacement with collector box and igniter wire.
charbroil ignitor electrode and collector bracket

Top view of ignition electrode shows the tip of the electrode where the spark will arc against the bent tab. There are small clips in the base of the collector box in addition to the small installation tabs like wings on the side of the collector box bracket.

charbroil kenmore bbq igniter

Here we can still see the electrode and the gap for arcing but the back end of the electrode is also apparent here. The back end of any ignition electrode is designed to allow the ceramic to protect the electrical material as it gets further away from the heat inside the barbecue. Many barbecue grills have very long back-end ceramic on their ignition electrodes while others have an internal fire wall inside the control panels.

This 803080 ignition comes with the electrode and the collector box which is attached to the electrode bracket with a small machine screw. There is alos an insulated electrode wire that is slightly less than twelve inches long with a female spade to attach to any type of ignition module.

803080

Kenmore replacement gas bbq grill ignitor electrode with collector box bracket and wire. Replace the electrode to repair the barbecue grill ignition. Collector box is tooled for installation with a lip on two sides. One end is bent-in towards the electrode to allow the gap to be adjusted for better sparking. The electrode wire is approximately 12 inches long with a female spade connector designed to plug into the barbecue module.

$12.


Free Shipping USA!!
kenmore gas barbeque grill repair electrode replacement with collector box and igniter wire.
Kenmore Ignition.

This electrode assembly works as a replacement ignitor on Kenmore model barbecues. If you are not certain that this is your igniter, please contact Majestic Grill Parts using either the email or telephone numbers listed on every page of the sute.

CharBroil Ignition.

There are Char-Broil barbecue models that use this ignition assembly. Check the Charbroil ignition to match the electrode if you are unsure. For assistance, contact Majestic grill parts.

See All Electrodes
natural gas and propane orifice holes drilled

888.346.6930

grill repair is secure