Charbroil Gas Barbecue Grill Replacement Parts and Fittings.

Universal 4 Spark gas bbq grill ignition module. AAA battery screws under button and nut hold module to control panel with 4 attachments for using up to 4 ignitor electrodes together. Less than 4 can also be used by grounding unused electrode attachments.

Replacement igniter electrode with mounting bracket and wire. This electrode fits several Charbroil model barbecues but is also so versatile that we can use this as a replacement ignitor in almost any gas grill. The steel rod is long enough to be safely bent or clipped and the bracket can be installed anywhere.

Replacement Ignition Electrode. Front bracket fits ledge inside Charbroil BBQ and mounting bolt tightens the electrode from within the control panel (see image below).

Replacement ceramic electrode, mounting bracket and male connector for gas grill universal ignitor repair.

Igniter Detail

Kenmore replacement gas bbq grill ignitor electrode with collector box bracket and wire. Replace the electrode to repair the barbecue grill ignition. Collector box is tooled for installation with a lip on two sides. One end is bent-in towards the electrode to allow the gap to be adjusted for better sparking. The electrode wire is approximately 12 inches long with a female spade connector designed to plug into the barbecue module.

Replacement control knob fits several model of Kenmore gas barbecue grill. D = 6.

Replacement control valve has pre-installed mounting bracket to connect controls and maniold. Clamp-On connection comes with clamp bracket and has a 45 degree angle for the original gas orifice.

Replacement control valve for Fiesta model barbecues. This control valve screws into the barbecue manifold and bends 45 degrees at the tip where the orifice attaches.

Attach barbecue and side burner to one propane cylinder with this T fitting adapter. T fitting splits gas hose so one gas line will feed gas to a barbecue and a side burner.
T Fitting Detail